Debugging Methods of Baby Concrete Mixer

Any part of wet concrete batching plant will have an impact on the overall situation, especially the condition of baby concrete mixer. Many customers consult on the debugging methods of baby concrete mixer and the following is detailed explanation.

Baby concrete mixer is mainly divided into horizontal single shaft type and horizontal twin shaft type and it is commonly used in the construction of scientific research units and construction companies.

Compared with self loading concrete mixer, this series of baby concrete mixer is easy to operate and clean with higher mixing efficiency and smaller residual amount which make it an ideal concrete mixing equipment in construction industry. In general, when debugging baby concrete mixer you should pay attention to the following aspects.

1. Check the reducer and the lubricating parts to make sure lubricating oil is sufficient.

2. Check whether the motor and the electrical components of connection are reliable and ensure that the power distribution box has a solid grounding. All the pipelines should be set properly to prevent accidents caused by crush.

3. The start mixing motor and the two half shaft rotation direction should be the same as the direction of the signs and if not, you need to change the power supply connection.

4. The hopper should work smoothly and can be stopped at the trajectory of arbitrary orientation. If there is a slipping phenomenon, you should put it into the hopper bottom and then adjust the big nut on the motor brake.

5. When the water pump is started, the water supply system should work normally.